Analog Mode question

superd2112 · Post by **superd2112** » Fri Feb 19, 2010 8:20 pm

The T-3 manual states that when in Master Mode/analog mode, the factory default setting is "Track". When I checked, mine was set to "pass-thru", and when I set it to track mode, the selected parameter's value will adjust up, but will not not adjust down below the preset's stored value - has anyone else experienced this? This only appears to be an issue when I'm in track mode - snap & pass-thru modes appear to be unaffected.

Update - this issue only appears to be occuring when, selecting the parameter to be adjusted, the control wheel is set below the preset's stored value - if the wheel happens to be above the preset's stored value, then the entire range of the parameter is available.

Amos · Post by **Amos** » Fri Feb 19, 2010 8:41 pm

Track mode is still a work in progress

-- we hope to have it all smooth and proper in the v1.1 firmware release (coming soon). Until then, that's why the default mode is Pass-Thru for now...

-Amos

superd2112 · Post by **superd2112** » Fri Feb 19, 2010 8:48 pm

Thanks Amos, I'm know you'll take care of us. When v. 1.1 comes out, will I be able to load it via USB cable, or will I need some sort of MIDI interface? I have a PC, running Windows-7 home edition, and computers and I don't always seem to play well together...

Amos · Post by **Amos** » Fri Feb 19, 2010 9:12 pm

We will provide a Windows executable firmware-loader program that you can use with USB. it's very fast and easy.

superd2112 · Post by **superd2112** » Fri Feb 19, 2010 9:26 pm

Amos wrote:We will provide a Windows executable firmware-loader program that you can use with USB. it's very fast and easy.

Amos, you rock... Btw, I would like to volunteer to be a beta-tester for future Taurus OS updates. I'm digging deep into this bad boy, and I'm lovin' every minute of it!

idemfred · Post by **idemfred** » Sat Feb 20, 2010 9:15 am

and for Mac user?

Mr Arkadin · Post by **Mr Arkadin** » Sat Feb 20, 2010 9:59 am

idemfred wrote:and for Mac user?

Guess it's time to check that dual-boot feature.

Amos · Post by **Amos** » Sat Feb 20, 2010 11:15 am

it's very easy for Mac users; a plain sysEx file and SysEx Librarian, USB cable.... is all you need.