Diameter of barrel used on MP-201 power supply

Kent · Post by **Kent** » Tue Oct 27, 2009 11:54 am

Hello folks,

I need to know the diameter of the barrel connector that is used on the MP-201 power supply. I have to make a 220V -> 12VAC supply for use in Europe.

The female connector is smaller than what I consider the 'norm' and is actually smaller than the ones used on the Moogerfooger pedals. What's the good word, y'all?

Kent

P.S. to be clear; I'd buy the 220V version directly from Moog if the shipping cost wasn't in excess of $77.

Amos · Post by **Amos** » Wed Oct 28, 2009 5:32 pm

From one of our engineers:

The answer is it is an EIAJ-3
4.75mm x 1.65mm Power Jack
Look for GLOBTEK G-EJ3
http://www.globtek.com/html/52.html
(the connector is on this page)

Mates to this..
http://www.cui.com/pdffiles/PJ1-021.pdf

Kent · Post by **Kent** » Thu Oct 29, 2009 1:03 am

Thank you for your assistance, good sir!