MiniMoog Osc 1 & 2 dead :-(

EricK · Post by **EricK** » Wed Oct 14, 2009 3:45 pm

lolol

And when you turn it on, all hell breaks loose.

MC · Post by MC » Wed Oct 14, 2009 5:40 pm

Make sure the tiny buffer board is working OK. You have to remove the oscillator board and EG board to get to it.

I think your power rails are fine if VCO3 is working.

An oscilloscope would really help here. All kinds of potential trouble points that you can't find with a DMM.

JohnLRice · Post by **JohnLRice** » Wed Oct 14, 2009 10:43 pm

thewaag wrote:MY GOD MAN! WHY DO YOU HAVE A MINIMOOG JUST LAYING AROUND ON IT'S END IN YOUR STUDIO??

Hey, reading is FUNdamental!

I said in my original post:

" . . .at one point I was rearranging things in my crowded studio and the MiniMoog was standing up on end temporarily while I was moving other stuff . . . "

Thank you for your concern and support!

EricK · Post by **EricK** » Thu Oct 15, 2009 12:38 am

Hey,
I think its great that you have a team of online surgeons on the case trying to help you patch her back together. This is a great place full of resourceful people.

Eric