Hey there,
I have two more questions regarding my minimoog restauration:
I can not mount the pitch and mod wheel perfectly horizontal on the pot shafts. They wobble just slightly and then almost touch the cutout of the panel when turned. Both wheels show some cracks and wear - could this be the reason?
The filter board mods are:
Change R2 from 47k to 160k
Change R8 and R28 from 27ohms to 4.7ohms
Change R40 from 1k to 10k
BUT on my boards as well as in the schematic R2 is 51k, R8 and R28 are 8.2ohms, and R40 is 2.2k. Should i ignore the difference of the original values and pop in the mod values anyways?
Thanks!