Minitaur LFO key sync not working with new firmware

[santokie]

Anyone else having this issue?

The firmware is fantastic otherwise...

[santokie]

To clarify, I'm talking about CC#82 which can be set to force the lfo cycle to reset each time a key is pressed. It isn't working since I downloaded the newest firmware.

[bichuelo]

It works fine here when changing the LFO key sync using Push with the Mintaur Editor loaded as a plugin in Ableton Live. What is your scenario?

[santokie]

I have the Minitaur connected to a midi controller keyboard and I'm using the keyboard to change CC#82 to 127. It used to make the LFO reset when a key is pressed and now it won't work.

[bichuelo]

I am able to test it tomorrow when I get back to our showroom, with an external controller

[bichuelo]

Indeed, there is something strange going on here. I found that it does work from an external controller without a DAW, as long as the LFO MIDI Sync (CC#87) value is set to off

Does that work for you?

[cousinofdeath]

bummer!

is it still saved w/ presets correctly?

[santokie]

I tried turning off CC#87 and it still doesn't work. I also realized none of my CC messages are working... I'll try going back to the previous version of the firmware later today. To be clear I am not using a DAW, just a keyboard with 5-pin MIDI out into the Minitaur.

All the presets remained intact, though.

Thanks for the replies!

[bichuelo]

I am reporting this to the developers' team

Could you please confirm if the value you are sending to CC#87 is zero or simply below 64? That might make a difference

[santokie]

I tried CC#81, 82, and 87 all at 0 and 127 and there was no change.

[santokie]

It worked for me to turn CC #87 off. It makes both 81 and 82 work no matter where they are set for me. Hope this helps others!