Issue:
At band practice today we ran through our entire set with no problems. Moog is being sequenced by an Electribe EMX-1 via midi. patches are manually selected on the front of the voyager. We went to start our second rehearsal run when at the end of the first song I noticed that the Filter Cutoff Pot wasn't affecting the actual cutoff anymore. Spacing, and Resonance don't seem to be working either.
The Screen will show changes in values when turning the knobs but no effect is heard. I can route LFOs to the Filter via mod matrix and the filter will sweep a bit from that but I can't manually control it anymore.
any ideas? Doesn't seem like it'd be a hardware issue since multiple pots stopped at the exact same time. then again. who knows...
