I discovered that I can't do midi learn of the LFO rate knobs when SYNC is enabled for the LFO's.
Took me a while to figure out, but it just doesn't. Disabling SYNC let's me.
Sub 37: Midilearn not possible with SYNC enabled for LFO ?
Sub 37: Midilearn not possible with SYNC enabled for LFO ?
Last edited by phy6 on Fri Feb 06, 2015 2:39 pm, edited 1 time in total.
-
_DemonDan_
- Posts: 1273
- Joined: Mon Nov 16, 2009 4:52 pm
Re: Sub 37: Midilearn not possible with SYNC enabled for LFO
Hi phy6,phy6 wrote:I discovered that I can't do MIDI learn of the LFO RATE knobs when SYNC is enabled for the LFOs. Disabling SYNC lets me.
An interesting find! I connected my Sub 37 to my Mac via USB and used MIDI Monitor to confirm that LFO 1 RATE was sending CC# 3, but *only* when its SYNC LED was dark.
What's far stranger is the fact that my Sub 37 (v 1.0.8 +1.0.9) *only responds* to CC# 3 when the SYNC LED is lit.
So... it only sends in one mode but only receives in the other mode. Weird.
Good catch, phy6!
Last edited by _DemonDan_ on Mon Feb 09, 2015 10:53 am, edited 1 time in total.
_ 
_DemonDan_ _
_DemonDan_ _-
_DemonDan_
- Posts: 1273
- Joined: Mon Nov 16, 2009 4:52 pm
Re: Sub 37: Midilearn not possible with SYNC enabled for LFO
I think one clue is that the owner's manual has CC#3 and CC#8 listed for LFO 1 and 2 CLOCK DIVIDERs (pg. 45) as well as for LFO 1 and 2 RATEs (pg. 46).
But...
The LFO CLOCK DIVIDERs and LFO RATEs have *different* Non-Registered Parameter Numbers (pg. 49-50):
LFO 1 RATE = NRPN 423
LFO 2 RATE = NRPN 448
LFO 1 CLOCK DIVIDER = 427
LFO 2 CLOCK DIVIDER = 452
But...
The LFO CLOCK DIVIDERs and LFO RATEs have *different* Non-Registered Parameter Numbers (pg. 49-50):
LFO 1 RATE = NRPN 423
LFO 2 RATE = NRPN 448
LFO 1 CLOCK DIVIDER = 427
LFO 2 CLOCK DIVIDER = 452
_ _DemonDan_ _
_DemonDan_ _