Problem Loading Sysex banks with MidiOx !

Nick Montoya · Post by **Nick Montoya** » Mon Oct 10, 2005 2:40 pm

I downloaded all 6 banks of ver 3.0 patches along with Midi OX to send them to the Voyager.
It works but only sends the first 101 patches, instead of sending all 128 of them. The progress bar
while sending the sys ex data will stop about 75% and prompt me with

"Sys Ex Output Devices: The port is transmitting data to the device. Wait until the data has been transmitted and then try again."

Then I check to see if the patches were sent in the first 75% of sending, and they were but the transmitting always stops at patch 101? I just got Midi Ox, am I doing something wrong? Or is it a Voyager setting?

Thanks for any help !

Simon · Post by **Simon** » Mon Oct 10, 2005 3:45 pm

I had a similar problem - try increasing the size/number of MIDI buffers in MIDI-OX - it worked for me. Go to Options->Configure Buffers... and make the changes there. My setup is: 512/32 for both input and output.

Simon

MarkM · Post by **MarkM** » Mon Oct 10, 2005 3:47 pm

Had the same problem. Changing the Midi Ox setting like Simon Says solved it.

Nick Montoya · Post by **Nick Montoya** » Wed Oct 12, 2005 11:56 am

Thanks Simon....

Worked great ! Yallz da bomb, ya hear..

Thankx

Nick Putrid