I notice that my Hi-Z output is very noisy. So I'm using the Low-Z to my amp, an old Hiwatt DR103, as it is dead quiet. Any issue with doing this due to impedance differences?
Anybody else notice this on your T3? Maybe I have a problem...
T3 Hi-Z output noise
T3 Hi-Z output noise
Rickenbacker 60's & early 70's 4001 basses ♦ Fender Pre-CBS J & P Basses ♦ Zon Sonus 8-string Bass ♦ Moog Taurus III Bass Pedals ♦ Hiwatt (Hylight) & Reeves Amplification
Re: T3 Hi-Z output noise
I have that problem. When I rec'd the T3 I posted about it, nobody else seemed to have the problem... maybe serial # related, maybe a faulty ground or something not put together well; obviously too large to have shipped back to Moog.
It's not terrible but it is annoying.
It's not terrible but it is annoying.
'76 Minimoog, Taurus 3, Oberheim FVS + Son of 2-voice; Sequential ProOne; Juno 106; Moog Model 15; Kurzweil 250; Hammond M3; and a handful of Fender Basses Flickr!