Does anyone have a picture of how to connect the Sample & Hold 1125 to the minimoog? I have tried several different ways but I’m not getting a response. It’s possible the cord or the 1125 sample and hold is not working but I just want to see how it’s supposed to be connected.
Thanks,
JOE MAD 
Hi,
The operating instructions are printed directly on the bottom of the S&H chassis.
Simply put, the six-pin Cinch/Jones connects to the back of any Moog with that mating connector (MiniMoog Model-D, Sonic VI, etc). Check for the pulsing red light on the 1125 to confirm that power is getting to your unit. Perhaps you are trying to connect to Voyager?
The Trigger plug (two-pin Cinch/Jones) goes to the trigger connector on the synth. The red and black 1/4"s can go into any combination of the OSC CV in (pitch), FILTER CV in and/or the AMP CV IN (loudness). It all depends on the kind of sound you are trying to create.
The red plug has “full” CV swing (+/-5 VDC) and the black swings about half that distance.
Hope this helps, have fun - they are very cool!
Osci-later,
Fig