Just Bought THE SOURCE - Out of Tune -

I am new to the analog synth world (tuning!) I am used to my MS2000 - -

The Keys are very out of tune - G is C etc etc – the problem is that octave one is worse than 2, actually the middle of the keyboard is ok - however the lower and higher ends are out of tune. Any suggestions on tuning here? The Fine tune does not adjust the pitch enough.

Is there an internal tuning control that I am not aware of?
Should I have it serviced?

I am familiar with electronics, and I am not afraid to crack her opened, but I could use some advice here.

Thanks

Jay –

PARTICLE PEOPLE UNITE!!
www.particlepeople.com

I think your Source needs calibration.

BTW: are both oscillators off pitch by the same amount? If yes, then it is a bit strange.

Schematics are here

http://www.encoreelectronics.com/cont_moogsup.html

Anyone know how to do this properly?

[quote=“warpjay2k”]Anyone know how to do this properly?[/Oliver]
You can can find the source service manual here:
http://oldschoolsound5.free.fr/manuels/Source_Service.pdf
The document include the calibration procedure and the full schematics.
hope it will be handy,
Oliver