My LP TE (running OS 1.03b) has crashed. I was saving a patch and when I pressed the enter button to confirm the overwrite the LCD went almost blank (backlight still on with just a “_” symbol on the display).
Now when I power up the LP, instead of running through the usual light-show all of the lights come on immediately and stay on and when I press the keys there is no sound.
In the light of recent news about soundcontrol (! talk about bad timing !) I was wondering if there was anything I could do to reset the unit / load the os again?
This forum doesn’t have the highest response rate.
You might want to call Moog. Occasionally they do not respond to my email via the support form. (I’m sure they are good folks, just probably busy or not used to email).
the exact same thing happened to me, but about 20 minutes out of the box. it sounds like your motherboard is messed up - i sent it back to moog and they replaced it free of charge (I did have to pay about 100 insured shipping though)
Thanks for the responses - i have tried emailing moog a couple of times via the email address on the website but have had no response. I am based in the UK so shipping would cost an arm and a leg.
Hi, sorry I didn’t see this. I have bee very busy trying to finish testing the new little phatty firmware and so I haven’t been active on the forum lately.
best would be to email me directly; amos at moogmusic d0t c0m.
We can certainly figure out a way to help. In fact, I have a plan already.
As a back-up plan, we do have an authorised repairer in London, and they’re great. So, we’ll get your synth back up and running, have no doubt.
