is there any way to control when the murf starts its steps? I’m trying to have two murfs sync together and can get the rate the same but cannot figure out how to get them to start at the exact same time so they are perfectly in sync
Any ideas?
thanks
i dont think there is a way and its one thing i miss
maybe try getting the tap tempo pedal then getting a 1/4 inch splitter so that the pedal’s signal goes to both murfs simultaneously.
theres still no way to reset the sequence
If you plug in HALF WAY on the Tap Tempo input jack, it should follow a trigger input (drum hit, click, etc). I haven’t done this for while but I know it works…
In other words - fully plugged-in looks for a SWITCH closing to set Tap Tempo. Halfway Plugged-in looks for an audio or voltage spike to trigger the next setp in your sequence. NOTE: this means you can do sequences that are NOT just timed 8th notes or whatever - they can trigger on each bass drum hit or another random timing source!
Try it and let us know…
That’s a nice method, i like that, cheers joe