EML-101 Filt-a-scape: Patch simulates an EML-101 thru dampened delay.
Adjust Osc 3 freq so rate of repeats in highest octave
of kbd is about 3.3khz or less. Add reverb to taste.
Oscillators:
Octave: Osc1 - 8’, Osc2 - 8’, Osc3 - 4’
Wave: Osc 1 - 9 (250), Osc2 - 9 (250), Osc3 - 7.9 (218)
Frequency: Osc 1 - n/a, Osc2 - +4 (+86), Osc3 - 0 (-1)
Mixer:
Level: Osc1 - 9 (241) ON, Osc2 - 8 (213) ON, Osc3 - 6.8 (181) ON
Noise - OFF, External - OFF
Filter:
Frequency: 8kHz (242), spacing: +1 (+55), Resonance: 3.9 (093),
KB Amount: 3.3 (076), Mode: HP/LP, Cutoff Slope A/B: 12db/12db,
Envelope Amount: -1 (-29).
Filter Envelope:
Attack: 12mS (059), Decay: 4 Sec (217), Sustain: 0, Release: 5 Sec (227).
Amplitude Envelope:
Attack: 13mS (061), Decay: 0mS, Sustain: 8.8 (229), Release: 1 Sec (199)
Env Gate: KB.
LFO:
Rate: 4.5 Hz (180), Lfo Sync: Off
Wheel Mod Bus: Source-Square, Destination-Pitch, Shaping:On/Pgm,
Amount: 2 (028)
Pedal Mod Bus: Source-Osc3, Destination-Filter, Shaping: On/Pgm,
Amount 5 (129).
Glide: Off, Release: On, Pitch Bend Amt: +/- minor third
1>2 Sync: Off, 3>1 FM: Off, Osc3 Kbd Ctrl: On, Osc3 Freq: Hi,
KB Mode: Low-note priority, KB Trigger: Multiple.
Master Volume: 6.2
Output config: Mono output/ No plug in B output.
Optional: Small bit of compression (tube or optical) to tame amplitude variations a bit. Reverb.
Regards,
LWG