Moog Music Forum

Hi

I see from the manual that to change the midi channel of the 108 or 104M, you have to send a midi control mode message. How do I do this? Can I do it from Logic?

Thanks

I have been sending a square wave into the tap/step input on the midimurf, and it seems to drift. Also, to get it to sync again it seems that I have to switch off the murf and reattach the wire. Anyone else experience this? Thanks

GregAE: that looks like a beautiful solution. However I lack your skills in this regard.

Just to be clear, IS there any problem with using the Beatstep Pro with moogerfoogers? On the Arturia homepage https://www.arturia.com/faq/utilization/beatstep-pro-general-questions it says that 10V "won't ...

Using various equipment, including 4 moogerfooger pedals (101, 102, 104M, 105M), looper and minibrute, I have some new live hardware-only tracks with WIERD grooves.



www.soundcloud.com/megacrex

Looked but did not see it. Thanks for replies

This. Anybody know?

In watts?

Peace

I just cleared a lot of space on the floor - almost all the warts are gone!

Thanks for your replies Bryan.

This is an interesting thread and I did some investigation of the behaviour of the CP's sample and hold module.

Set-up: CP S&H modulates cut-off of self-resonating filter on 101. I have 2 cps and I include the results with each.

Direct modulation of 101 cut-off, S ...

Thanks Greg.

hellomikmik: I plugged the S&H into the freq input, and the osc out, er, out. No problems there

Thanks so much for the reply Greg. It was strange because I found the output from the S&H was surprisingly small, especially considering the range of the other waves.

I tried routing multiple copies of the S&H to the mixer, and oddly it didn't do much. In fact, the chief result of sending more ...

Hi

I get a much smaller range when using the unattenuated S&H from CP251 on a freqbox osc out than on 101 cutoff. But in both cases the range is less than one might expect. On the freqbox the pitch varies by about a minor 3rd at most.

Is this normal or have I got power issues?

Hello again

I got my 8-step yesterday and I have found it a lot of fun with foogers, though I REALLY wish that there were more steps available. Still, by having it run in "bounce" mode I got it to play in 14/8. 8)

Does anybody know of a relatively inexpensive CV-sequencer with up to 16 ...

I just ordered an 8step, looking forward to finding out what it can do... wil post

Guess it is a bit early to ask this question, but has anybody tried the Zuma with foogers? 500ma is ok for foogers? Is it just to find the right cables to switch polarity?

Here's my current portable looping setup, starring two foogers.