Moog Music Forum

We were cheaper then Keith Emerson!

dave

http://kopb.opb.org/~dfulton/Reaves_Ful ... =S00CAB27F

Ok I am a dork! Sorry I missed this most obvious post.

The highest value it got to was 239 or so. After I trimmed to zero there appeared to be a fair amount of range at that zero point so I could move it around at the high end but never get zero to 255 without the bounce at the low end.

Thanks ...

I suppose it does not have to go to 255, but that would make sense that it would. If there is no offset control then it might be done in software.

Again anyone in tech support out there?

dave

I would assume 255. Anyone from tech support care to comment?

dave

I went ahead and adjusted the Mod trim to 0 but I no longer could hit 255 at full throw. Is there a scaling control? If not I think the pot is bad. Since it can be forced to 0.

dave

I will attempt to deal!

Next question when I move the mod wheel all the way down to off, the value on the offset page alternates between 0 & 3. If I hold it all the way down it stays at 0. Is this normal?

Do I need to trim it out?

Can I ?

dave

Hi there,

I am seeing the same.

With version 2.5? It drives my Nordlead 3 nuts.

dave

It's true. I cannot find the DL's using Safari.

But a cut and paste of the URL works.

dave

I love the update but I noticed (maybe it was like this before.) that when you hit the master button while holding keys down (and sending midi notes out),
the voyager sends an "all notes off" out, turning off my midi modules.

Am i missing something?

dave