Changing start step of M32 Sequencer

Mother-32, DFAM, Subharmonicon, Grandmother, Matriarch
Post Reply
davemoog
Posts: 9
Joined: Tue Dec 11, 2007 12:45 pm
Contact:

Changing start step of M32 Sequencer

Post by davemoog » Sat Jun 03, 2023 6:33 pm

In the Mother 32 it is possible to set a new (shorter) end of sequence. This works fine. However thru some weird and not remembered key presses I seem to occasionally change the start point. For example if I have a 24 step sequence I have somehow gotten a 16 step sequence starting at step 9. If you stop and reset the sequence then it will start then with step 1 then loop from step 9 to step 24. Any ideas what’s happening? I have used the Mother32_restore_defaults.syx but fault still happens.

DoMath
Posts: 2
Joined: Sun Jul 16, 2023 7:28 am

Re: Changing start step of M32 Sequencer

Post by DoMath » Sun Jul 16, 2023 7:42 am

Hello ,
Found any solution ?

Post Reply