DFAM issues or normal?
Posted: Sat Sep 04, 2021 6:51 am
I got a new DFAM and I think it has some issues:
first: when I touch the surface it, it feels a bit static loaded - ticklish - hard to describe. I tried a PSU from a Mother 32 and different outlets - its everywhere the same.
second: when I plug a cable in the Noise Level and send cv from a sequencer (0-control) it works just fine - but if I unplug from 0-control so the Input to Noise Level stays plugged, but the other end is free - noise goes high, and sometimes when I touch the open end of the cable, it goes low again and sometimes up again. shouldn't it got silent when nothing is sent? would someone be so nice to test this on their DFAM?
with some cables from the 0-ctrl clock out to the Adv/clock input the sequencer starts running wild, the cable itself works fine on everything else.
maybe everything is normal on this machine, I don't think the DFAM in the showroom I tried before had for instance this tickly surface....
do you think i should drive back there and try it with the show room model and eventually exchange it?
first: when I touch the surface it, it feels a bit static loaded - ticklish - hard to describe. I tried a PSU from a Mother 32 and different outlets - its everywhere the same.
second: when I plug a cable in the Noise Level and send cv from a sequencer (0-control) it works just fine - but if I unplug from 0-control so the Input to Noise Level stays plugged, but the other end is free - noise goes high, and sometimes when I touch the open end of the cable, it goes low again and sometimes up again. shouldn't it got silent when nothing is sent? would someone be so nice to test this on their DFAM?
with some cables from the 0-ctrl clock out to the Adv/clock input the sequencer starts running wild, the cable itself works fine on everything else.
maybe everything is normal on this machine, I don't think the DFAM in the showroom I tried before had for instance this tickly surface....
do you think i should drive back there and try it with the show room model and eventually exchange it?