D reissue "drone" options
Posted: Fri Nov 27, 2020 1:56 am
feeding +5v into the "gate" input on the back, keeps the oscillators running and works great for drones
it's a bit of a pain to always plug an external device in, to supply the +5v. Also if I bring the minimoog somewhere it's more crap to haul
So I was thinking, in order of least invasive options:
1. reading the manual, it says the OSC, VEL, FILTER external control jacks all supply +5v on the ring, to power expression pedals. So it should be possible to build a TRS-->TS cable that could feed +5v into the gate (?). Although it says it's current limited. which is probably a good thing. So all you need to do is plug that cable between them...disadvantage is, you lose a controller input on the D
2. drill a 1/4" hole in the back and wire it to +5v. So you could use any 1/4" cable, and also keep the external control jacks free
3. install a proper switch on the front. Lots of room, say over the headphone jack. It would look great if done with a matching Moog style switch. But square holes are a pain, and am not keen on modding the front of the unit
Anyone else have any thoughts? Is there another option, that could be easier, or less invasive?
thx
it's a bit of a pain to always plug an external device in, to supply the +5v. Also if I bring the minimoog somewhere it's more crap to haul
So I was thinking, in order of least invasive options:
1. reading the manual, it says the OSC, VEL, FILTER external control jacks all supply +5v on the ring, to power expression pedals. So it should be possible to build a TRS-->TS cable that could feed +5v into the gate (?). Although it says it's current limited. which is probably a good thing. So all you need to do is plug that cable between them...disadvantage is, you lose a controller input on the D
2. drill a 1/4" hole in the back and wire it to +5v. So you could use any 1/4" cable, and also keep the external control jacks free
3. install a proper switch on the front. Lots of room, say over the headphone jack. It would look great if done with a matching Moog style switch. But square holes are a pain, and am not keen on modding the front of the unit
Anyone else have any thoughts? Is there another option, that could be easier, or less invasive?
thx