Matriarch Evenlopes Sustain turned down, still sending voltage
Posted: Sat Oct 31, 2020 10:04 am
Hi everyone!
Bought a Matriarch a couple of months ago and I'm super happy with it, but since it's my first analogue synth I don't know if this is an actual issue or just the normal behaviour of this kind of machines.
Anyway, I was trying to modulate the pitch via one of the envelopes (later I've tried both of them), doing so by patching ENV OUT to PITCH IN of osc 1.
The problem is that even with sustain at zero, pitch is still affected almost for a halftone up at the end of the envelope; if I take off the patch cable while playing a long note I can hear the note descending to its right pitch, when I connect it again I can hear the note going up, as the envelope couldn't help to send a small voltage even with all knobs turned down and sustain fader at zero.
Oscillators are calibrated, also pots are, the firmware installed is the latest.
Is this normal or there's something I can do about any further calibration, or what else?
Thanks!
Bought a Matriarch a couple of months ago and I'm super happy with it, but since it's my first analogue synth I don't know if this is an actual issue or just the normal behaviour of this kind of machines.
Anyway, I was trying to modulate the pitch via one of the envelopes (later I've tried both of them), doing so by patching ENV OUT to PITCH IN of osc 1.
The problem is that even with sustain at zero, pitch is still affected almost for a halftone up at the end of the envelope; if I take off the patch cable while playing a long note I can hear the note descending to its right pitch, when I connect it again I can hear the note going up, as the envelope couldn't help to send a small voltage even with all knobs turned down and sustain fader at zero.
Oscillators are calibrated, also pots are, the firmware installed is the latest.
Is this normal or there's something I can do about any further calibration, or what else?
Thanks!