Moog Music Forum

Deva wrote: I would like LFO Start Phase as a destination.

Thanks, Deva. I have copied it to this new thread.

I'd like to see *all* parameters available as destinations. There are a lot of parameters behind the 'MORE' buttons...

EGs and LFOs to CV Outs

- All Synth effect params (available dynamically after assignment). Use case would be modulating resonator params, etc... Deleted or disabled if effect is changed?
- Master effect params (available dynamically after assignment). Reverb modulations...
- X/Y Value. Use case is to give very precise movement to modulation params in a visual way (i.e. can see on LHC more panel)
- SVF / Ladder Filter Slope
- Detune parameters (Detune, Unison Count, both analog drift params...)
- LFO 1-4 Rate, Blend

I think that would keep me busy for a very long time...

(Cross post from other places, sorry for the dupes on this one.)

Dest request:
Allow a mod source to modulate the gate %age of a step in a sequence or arpeggiator.

CV/Outs as destinations in the sequencer

Insert buss levels as a mod source. Not the send level, the return level. There is currently, unless I am missing something, no way to adjust let alone modulate the levels of the insert returns.
I hesitate to even call them inserts as they are really more like aux sends.

Hi!
I don’t know if this has been asked before, but would it be possible to have Unison detune as a Mod destination?
That would be great
Thanks!
V