Mother 32 firmware 1.0.2 update
Posted: Sat Mar 03, 2018 1:57 am
Anyone here on the 1.0.2 firmware of the mother? I’ve updated recently to this after I raised a ticket on mum not working well with midi (that it wouldn’t respond to incoming midi notes during playback but suddenly respond after I’ve stopped 
) I’ve been facing some changes with the way the sequencer set end position is edited after updating to this firmware. There seems to be no monitor in the change log about it! Wanted to know if anyone else out here is experiencing the same set end pattern bug.
What’s changed is when I press shift set end and try to close a 32 step pattern into the first page of the sequence it does the reverse. It omits out the first page and plays the last three pages(24 steps) of the sequence. It’s different to how it behaved on the version of the firmware.
Any insight would be appreciated!
) I’ve been facing some changes with the way the sequencer set end position is edited after updating to this firmware. There seems to be no monitor in the change log about it! Wanted to know if anyone else out here is experiencing the same set end pattern bug. What’s changed is when I press shift set end and try to close a 32 step pattern into the first page of the sequence it does the reverse. It omits out the first page and plays the last three pages(24 steps) of the sequence. It’s different to how it behaved on the version of the firmware.
Any insight would be appreciated!