Sequence on Sub 37 not completing?
Posted: Mon May 29, 2017 1:30 pm
Hello -
New Sub 37 user and new forum member here. I've had my instrument for a little over a week and I am absolutely loving it. Whenever I think something may be wrong, I am quick to remind myself that it is probably me and not the instrument. That being said, last night I noticed an issue with playing back sequences. Specifically, I found that the sequence would run only until the 23rd step at which point it would skip back to the start of the sequence. At first, I thought I may have inadvertently set a last step in the sequence but this was not the problem. This morning, I reset the instrument to the factory presets and then programmed a 32-note sequence; this played all the way through until the end with no problems. However, after about five hours after resetting and playing around for a few hours, I input another 32-note sequence and the same thing happened: when the sequence reached the 23rd step it would skip back to the beginning and not complete the entire 32-note sequence.
Again, I am assuming that this might be something I am doing but I can't figure out what it might be. Do any more experienced users have an idea of what might be happening?
Thanks in advance,
John
New Sub 37 user and new forum member here. I've had my instrument for a little over a week and I am absolutely loving it. Whenever I think something may be wrong, I am quick to remind myself that it is probably me and not the instrument. That being said, last night I noticed an issue with playing back sequences. Specifically, I found that the sequence would run only until the 23rd step at which point it would skip back to the start of the sequence. At first, I thought I may have inadvertently set a last step in the sequence but this was not the problem. This morning, I reset the instrument to the factory presets and then programmed a 32-note sequence; this played all the way through until the end with no problems. However, after about five hours after resetting and playing around for a few hours, I input another 32-note sequence and the same thing happened: when the sequence reached the 23rd step it would skip back to the beginning and not complete the entire 32-note sequence.
Again, I am assuming that this might be something I am doing but I can't figure out what it might be. Do any more experienced users have an idea of what might be happening?
Thanks in advance,
John