Page 1 of 1
Sub37 Editor not controlling filter + other functions
Posted: Tue Nov 22, 2016 3:10 am
by hillz-Ize
Can anyone tell me why when I turn the Filter in the Software, I dont get any change or response on my SUB37. Alot of other parameters respond fine, but the Filter and alot of other main functions will not be changed from the software.
?
Re: Sub37 Editor not controlling filter + other functions
Posted: Tue Nov 22, 2016 12:24 pm
by DrJustice
It should Just Workâ˘...
That said, I had some funnies with the editor today. The editor would not start properly, just hanging with that white rectangle in the upper left corner of the screen. I had to reboot the PC, then it appeared to work. However, the Sub 37 had then become bugged, possibly by that hanging editor - the editor would send patches and edit parameters on the Sub 37, but CAPTURE HARDWARE and GET patches would not work, and edits on the Sub would not be reflected in the editor. Had to power cycle the Sub to get it all working. I.e. the Editor/Sub combo can get its knickers in a twists and need a fresh start. Edit: this was on Windows 10 using the stand alone editor, BTW.
Re: Sub37 Editor not controlling filter + other functions
Posted: Wed Nov 23, 2016 1:20 am
by hillz-Ize
I have those problems aswell, but no matter what I do, its still only 'semi' working. The sequencer works / an some other stuff (i havnt ran the software in awhile) ....some knobs etc. But the essentials+ dont respond or trigr the hardware
Re: Sub37 Editor not controlling filter + other functions
Posted: Wed Nov 23, 2016 1:21 am
by hillz-Ize
Maybe its cause im on El Capitan?