Page 1 of 1
Recalibrating sub 37 pots after board 2 replacement
Posted: Thu Oct 27, 2016 6:53 am
by Hafhaf
I am new to sysx and have followed the instructions regarding downloading Midi-ox on my lap top and I I have the 3 calibration files. Running the low pot one now. It's been half an hour and the midi light is still red. Lots of lines of text on the midi-ox output display. How long should the procedure take? not knowing this means I don't know if it's all working. How long before the red midi light flashes? Thank you!
Re: Recalibrating sub 37 pots after board 2 replacement
Posted: Thu Oct 27, 2016 7:21 am
by Hafhaf
Have I got the midi port routing right?
Re: Recalibrating sub 37 pots after board 2 replacement
Posted: Thu Oct 27, 2016 7:22 am
by Hafhaf
A screen shot.
Re: Recalibrating sub 37 pots after board 2 replacement
Posted: Thu Oct 27, 2016 7:51 am
by DrJustice
From your description and the screen shot, it looks as if there might be a MIDI loop. What are the physical MIDI connections you're using?
I can't test with MIDI-OX at the moment, but you can take these steps to eliminate any loops, and then give it another go:
- Do not connect the MIDI out on your Sub 37 to your PC (just leave it unconnected).
- Make sure any MIDI through functions on the Sub 37 are switched off.
To do this, press the MIDI button and set the ECHO functions to off:
MIDI MENU 2.3 > ECHO DIN IN: OFF
MIDI MENU 2.4 > ECHO USB IN: OFF
Re: Recalibrating sub 37 pots after board 2 replacement
Posted: Thu Oct 27, 2016 10:21 am
by Hafhaf
Many thanks for you assistance. I only had a single USB single USB connecting the sub to the lap top. I adjusted the subs midi settings as suggested an voila! The midi light flashed red in a second. Iam off to try it out and will let you know. Many thanks again.
Re: Recalibrating sub 37 pots after board 2 replacement
Posted: Thu Oct 27, 2016 11:49 am
by Hafhaf
Hi again. Thanks again for your support! Pleased to say the sub 37 is once again fine and dandy.
