Page 1 of 1
Drift with tap/step on 105M?
Posted: Sun Oct 09, 2016 3:57 pm
by deadhedgehog
I have been sending a square wave into the tap/step input on the midimurf, and it seems to drift. Also, to get it to sync again it seems that I have to switch off the murf and reattach the wire. Anyone else experience this? Thanks
Re: Drift with tap/step on 105M?
Posted: Mon Oct 10, 2016 11:46 am
by latigid on
Can you explain (/audio/video) further? What's drifting? Relative to what? What's your clock source? Is it stable? Are you sending MIDI too?
I think the MuRFs might trigger on a falling edge, so if it seems out you could try inverting your squarewave before sending it to the tap/step input.