Page 1 of 1
Sub 37: Midilearn not possible with SYNC enabled for LFO ?
Posted: Fri Feb 06, 2015 11:46 am
by phy6
I discovered that I can't do midi learn of the LFO rate knobs when SYNC is enabled for the LFO's.
Took me a while to figure out, but it just doesn't. Disabling SYNC let's me.
Re: Sub 37: Midilearn not possible with SYNC enabled for LFO
Posted: Sun Feb 08, 2015 5:29 am
by phy6
anyone ?
Re: Sub 37: Midilearn not possible with SYNC enabled for LFO
Posted: Mon Feb 09, 2015 10:38 am
by _DemonDan_
phy6 wrote:I discovered that I can't do MIDI learn of the LFO RATE knobs when SYNC is enabled for the LFOs. Disabling SYNC lets me.
Hi phy6,
An interesting find! I connected my Sub 37 to my Mac via USB and used MIDI Monitor to confirm that
LFO 1 RATE was sending CC# 3, but *only* when its
SYNC LED was dark.
What's far stranger is the fact that my Sub 37 (v 1.0.8 +1.0.9) *only responds* to CC# 3 when the
SYNC LED is lit.
So... it only sends in one mode but only receives in the other mode. Weird.
Good catch, phy6!
Re: Sub 37: Midilearn not possible with SYNC enabled for LFO
Posted: Mon Feb 09, 2015 10:52 am
by _DemonDan_
I think one clue is that the owner's manual has CC#3 and CC#8 listed for LFO 1 and 2 CLOCK DIVIDERs (pg. 45) as well as for LFO 1 and 2 RATEs (pg. 46).
But...
The LFO CLOCK DIVIDERs and LFO RATEs have *different* Non-Registered Parameter Numbers (pg. 49-50):
LFO 1 RATE = NRPN 423
LFO 2 RATE = NRPN 448
LFO 1 CLOCK DIVIDER = 427
LFO 2 CLOCK DIVIDER = 452