Moog Music Forum

When i save a Cubase Track incl. the Minitaur VST Editor and reopen this track, the editor lost all settings. All editor controllers are set to zero. But the Minitaur itself gets the settings wich are stored with the song. This is since updating the editor to V3.

2nd problem is that automation data only are written when turning the knobs on the editor. When move the knobs on the hardware, the editor knobs are moving too but there is no automation written.
I had the same automation problem with editor V2.

I cant load my old tracks anymore, because of the problems with V3. So where can i download the version2 of the editor?

I´m on my end!! I spend 6 hours to get my setup and my tracks working again - without any success.

After updating the firmware it is possible for one time only to save a Cubase track wich loads the Editor settings after reloading the track. But the next saved track doesnt reloads the editor settings.

I made some photos to demonstrate it.

I´m so frustrated about this disappointing update. I hope someone could help me.