Hi -
The Emerson Moog offered includes the modifications requested by Emerson. One of the units modified is 905 reverberation modules.
*** Unique to Keith Emerson’s Original System ***
• Standard Moog 905 module
• PCB created from original factory trace layout films
• Internal standard 6” reverberation tank replaced with RCA jacks on rear of module to connect to external reverberation tank
• Additional audio input jack added
• Wet/Dry mix front panel control modified to provide wet mix only (dry signal is always passed through unaffected)
- I can find & install a 6" reverb tank, but how is the module revised so that Wet/Dry mix front panel control modified to provide wet mix only (dry signal is always passed through unaffected).
I haven't a clue where to start with this, but it seems like it would be a simple mod to do. Any help would be appreciated.
Thank you
Larry
Emerson Mod to 905 Reverberation
- noddyspuncture
- Posts: 467
- Joined: Wed Sep 16, 2009 7:57 pm
Re: Emerson Mod to 905 Reverberation
It would involve taking the in/out wires from the dual gang potentimeter (wiper and one end of the track - not the ground side)... on the "dry" half and simply shorting them together permanently. Leaving the 'wet' signal still running through the pot's other half.
Actually you could install a switch so you could switch between the two modes.
Interesting - I might do this mod myself....
Cheers,
Tom
Actually you could install a switch so you could switch between the two modes.
Interesting - I might do this mod myself....
Cheers,
Tom
Re: Emerson Mod to 905 Reverberation
Thank you very much for the response.
Looks like any easy mod to do.
Thanks again
Larry
Looks like any easy mod to do.
Thanks again
Larry