Minitur USB issues!
Posted: Fri Sep 27, 2013 2:35 pm
Got it today. updated to latest firmware as instructed, installed editor and everything was working fine.
then after a few hours it just started not working properly. the knobs were unresponsive and the editor didnt not move with the knobs on the moog.
After trying everything mentioned on the forums, and reinstalling the firmware various times including the factory reset .syx file i found an a forum post.
None of this worked and it just ened up going silent and not working.
Ive now taken out the usb and put a midi cable in, and now it works fine. So clearly there is a serious issue with the firmware and USB connection.
Anyone else had similar? MIDI is fine but unable to record automation.
then after a few hours it just started not working properly. the knobs were unresponsive and the editor didnt not move with the knobs on the moog.
After trying everything mentioned on the forums, and reinstalling the firmware various times including the factory reset .syx file i found an a forum post.
None of this worked and it just ened up going silent and not working.
Ive now taken out the usb and put a midi cable in, and now it works fine. So clearly there is a serious issue with the firmware and USB connection.
Anyone else had similar? MIDI is fine but unable to record automation.