Sub Phatty ENV RELEASE problem after new firmware update

[sidamosae.be]

I updated my Sub Phatty to the latest firmware.

The ENV RELEASE knobs don't do anything anymore, in all my existing patches the filter / amp release stage is GONE.
Even in all provided Patch Libraries there is no release stage.
Same goes for when creating a new patch from 'Active Panel': sound dies when keys are released, even when sustain is fully up.

Am I overlooking something (like by mistake adjusting a hidden global setting which affects this?) or is it a bug?

[sidamosae.be]

The problem seems to be solved after power cycling .

[red]

had the same effect... after a power on reset it was gone - was not able to reproduce it

[myshell]

I have ENV release issues as well as other issues after firmware update...and installing the editor. Hanging notes, Editor crashes...etc etc

[myshell]

Yes I have the ENV release issue after the firmware update and editor install. As well as other issues such as hanging notes and crashes

[440hz]

I have also the release (Amplifier Envelope) which did not work, and went OK after a power off.

Appeared twice.

[bandmasta]

The same hanging note and crash here.

[mixpan]

Since the update and install of the editor SP became unusable in my DAW. It starts with the first note, hangs there and needs turning off...
VST Editor always shows hardware not being connected.
I think something is wrong with the USB connection.

[retrograter]

I had crashes, notes hanging and the octave button only going from the highest to the lowest step when pressing it. It would just skip the middle steps. Im also unable to get the synth to receive USB midi signals from Ableton (on a mac). At one point all sound disappeared completely until i left "Active Panel" mode. After turning it off and on again everything was working normal until I load up the editor as a vst. In standalone it seems to work a little better, but as a vst and au I was having no luck at all making it work properly.