Page 1 of 1
Spacing panpot
Posted: Thu Jul 24, 2003 7:41 am
by sergio
Hi,trying the spacing feature in Dual LP mode,I noticed that increasing the spacing value,is the left VCF that increases the frequency and not the right VCF as mentioned in the manual.
Am I doing something wrong,or did anyone else run into this problem?
Bye
Posted: Thu Jul 24, 2003 10:53 am
by SynthBaron
Nope, that's how it's supposed to work.
Posted: Thu Jul 24, 2003 11:04 am
by sergio
So my Voyager has a panpot problem.
I think I'm going to invert the output cables
Thanks
Posted: Fri Jul 25, 2003 2:46 pm
by mpulver
sergio wrote:So my Voyager has a panpot problem.
I think I'm going to invert the output cables
Thanks
Hi Sergio;
Don't swap the output cables, your Voyager is fine - it's just a misprint in the manual. All of the Voyagers are working just like yours.
Mark
Posted: Fri Jul 25, 2003 6:02 pm
by sergio
Yes,I know.
In the pdf addendum,infact,say that filter B in dual LP mode is controlled by the spacing knob and his signal is on the left output.
I feel better know
The sound of this synth is incredible!!!
Posted: Tue Dec 02, 2003 10:00 am
by BrianK
Yes - to clarify:
There was no need to move BOTH filters when "spacing" them - you only need to move one. So the knob sets the distance that the filters are apart, it does not move both filters to do that...