Moog Music Forum

Hello,

My MF-104m dose not always catch on to the first midi event sent from my sequencer (starting) most of the time it does though sometimes I have to start it a few (three four times) to get it to start syncing (LFO rate LED turning amber) to Ableton.

My MF-108m is fine.

Its not to much of an issue, I thought I would post this in case the Moog techs are reading this forum to find possible bugs.

It could well be I have both my MF's sending on channel one?

Cheers

I Have the same problem. I'm using my Roland Fantom G sequencer to send midi CC's to the mf 104m, and often it seem to go wrong (wrong delay time, or feedback, or lfo settings). I have to play the track 2 or 3 times before it catches the appropriate settings...deceiving...

What exactly is the setup you have when you are experiencing this issue? (MIDI interface, MIDI Ins/Outs, Clock Source, Sequencer, DAW, number of MIDI pieces in the chain, etc.)

Would like to re-create this to see if it is an issue that should be looked into further.

Thanks!

High quality digiflex midi cable (10') plugged directly from the midi out of my fantom G7 to the midi in of the MF-104m