Page 2 of 2
Posted: Wed Oct 14, 2009 3:45 pm
by EricK
lolol
And when you turn it on, all hell breaks loose.
Posted: Wed Oct 14, 2009 5:40 pm
by MC
Make sure the tiny buffer board is working OK. You have to remove the oscillator board and EG board to get to it.
I think your power rails are fine if VCO3 is working.
An oscilloscope would really help here. All kinds of potential trouble points that you can't find with a DMM.
Posted: Wed Oct 14, 2009 10:43 pm
by JohnLRice
thewaag wrote:MY GOD MAN! WHY DO YOU HAVE A MINIMOOG JUST LAYING AROUND ON IT'S END IN YOUR STUDIO??
Hey, reading is FUNdamental!
I said in my original post:
" . . .at one point I was rearranging things in my crowded studio and the MiniMoog was standing up on end temporarily while I was moving other stuff . . . "
Thank you for your concern and support!
Posted: Thu Oct 15, 2009 12:38 am
by EricK
Hey,
I think its great that you have a team of online surgeons on the case trying to help you patch her back together. This is a great place full of resourceful people.
Eric