the big inputs at the back of the 15

[stoke175]

hi - sorry if this has e been covered already but---
im patching in through the front of my model 15 and love it
have zero use for the panel section thats labelled controller input irks me a bit
is there a way to get hold of a cable for one of those crazy barrel inputs at the back or somehow reconfigure the panel on the from to accept gates and cv's
seems a waste of real estate otherwise

[EricK]

Your system should be able to accept gates and CVs via the Amphenol socket on the rear and then route those to your front panel for multiplication and distribution, right?

So if you could mod that front panel to accept cv then couldn't you simply wire up a cable to an Amphenol barrel?

[stoke175]

any idea what the tech spec of that Amphenol socket is?
best place to order?

[EricK]

You might be able to find that in the Moog 15 Service Manual and get the barrel from Mouser.

[leo]

i was wondering, did you find the connector ?
i have the same question regarding the model 10 and i assume the right connector and knowing the pin lay out, should be enough to solder a cable that can supply at least 1 trigger and 2 cv signals from jacks ??!!

thanks for any help and/or suggestions.