Hi,
I'm currently putting my Dotcom system through my Model 10 via the mixer module. The Dotcom output is much louder than the Model 10s 901s and I wondered if there is a risk of damaging the mixer by introducing very hot signals - or will it just nicely overdrive?
many thanks
Paul
Model 10 Mixer question
- PaulLawler
- Posts: 47
- Joined: Fri Oct 12, 2012 2:54 pm
- Location: UK
- Contact:
- AlakaLazlo
- Posts: 77
- Joined: Mon May 04, 2009 7:18 pm
- Location: Los Angeles, CA
- Contact:
Re: Model 10 Mixer question
Hi Paul,
I've run my DotCom oscillators into my vintage Moog CP3s many times. They tend to clip a bit (which is part of the Moog mojo) but have shown no sign of damage.
I've run my DotCom oscillators into my vintage Moog CP3s many times. They tend to clip a bit (which is part of the Moog mojo) but have shown no sign of damage.
Moog IIP, One 16V and MiniMoog, DotCom/FSFX/Moon/STG 110, Cubase 12Pro, Ableton Live 10/64, RME UFX+, 2xMR816, MioXL, Expressionist, Cirklon, Analog Rytm Mk II, Axon AX50, Customized Variax JTV69s (the Hexstainocaster), Strat, Godin ACS Slim, Helix.
- PaulLawler
- Posts: 47
- Joined: Fri Oct 12, 2012 2:54 pm
- Location: UK
- Contact:
Re: Model 10 Mixer question
Ah I thought as much, clipping is fine.
many thanks
many thanks
Re: Model 10 Mixer question
when I mix moog (+/-5V) and eurorack (+/- 10V in my case), I use the 995 attenuators for point to point connections from euro to moog. the other way, usually isn't a problem.
VoyagerEB, Minitaur, LittlePhattyII, 4xSlimPhatty, Sub37, MF[2x101,2x102,103,104M,105,105B,105M,2x107,108M], 3xCP251, XV351, MP201;
2xMother 32, DFAM, Subharmonicon;
System 55 and Minimoog clones with lots of mods.
2xMother 32, DFAM, Subharmonicon;
System 55 and Minimoog clones with lots of mods.
- PaulLawler
- Posts: 47
- Joined: Fri Oct 12, 2012 2:54 pm
- Location: UK
- Contact:
Re: Model 10 Mixer question
Thanks, this was just audio from dotcom into the model 10 mixer. Moog support said it’s fine too although it is possible to damage the mixer so to take care with audio levels.
-
- Posts: 2
- Joined: Wed Apr 20, 2022 3:16 am
Re: Model 10 Mixer question
I have the same problem, I think it's overloaded.