Needed to replace an LFO switch that no longer functioned. Moog send me the switch but as I’m unable to solder, I bought a whole new left hand board and installed it
I was then told to send it a file, but I could not get it to work.
The synth is recognised by the Moog editor software and movement of knobs is registered on the computer but I’ve overwritten something in the software and now it just shows all lights lit up
As the buttons don’t do anything, I can’t get it in firmware install mode
Any ideas how to get it out of this situation ??
Sub Phatty frozen.
Re: Sub Phatty frozen.
Would the USB debug route work on this like it did on several users Phatty’s?