minitaur no working with analog four CV GATE

[cuca123]

hi all guys. Can somebody please help me step by step how configure analog four with moog minitaur or moog minitaur with analog four via CV / GATE ? i can´t get any pitch. I have more cv synthesizers and they dont give problems, all except minitaur. I installed the latest firmware and have followed some instructions in other forums but no good results. its a nightmare, i use the calibration cv tool in the editor but its impossible to fix this problem.
i have note 1 > "c2" 1.000volts note 2 > "c5" > 4.000 volts pitch/oct
thanks and sorry for disturb.

[SlowLFOtoPitch]

**Minitaur Pitch CV Calibration Procedure**

- Connect the voltage source to the Minitaur's pitch CV input.

- Now connect the Minitaur to your computer via USB and open the Minitaur Editor.

- In the editor settings, locate the 1 volt and 4 volt calibration options.

- Send 1 volt signal from your voltage source into the Minitaur, then click the Pitch CV Calibration +1v button. You will see the MIDI light on the Minitaur blink.

- Send 4 volt signal from your voltage source into the Minitaur, then click the Pitch CV Calibration +4v button. You will see the MIDI light on the Minitaur blink.

- This ends the pitch CV calibration procedure. Please test with a 0-5v CV source.

If this does not correct the issue, please contact us directly and we will be more than happy to help.

Adam Pryor
‪[email protected]‬‬
(828) 251-0090 Ext. 246

Harrison Street
‪[email protected]‬‬
Ext. 221

Noah Jolly
‪[email protected]‬‬
Ext. 204

Thank you,

Taylor Mott
Service Manager
‪[email protected]‬‬
Ext. 217

[cuca123]

thanks but it doesnt works .