Hey there,
i got my minitaur today and was really happy, everything worked nice in combination with my roland pk5 base pedal. Then I connected the Taur via usb to my laptop and updated the firmware. when I put it back on the amplifier and the pk5 there wasn't any output signal anymore. so i tried the "hit the 4 buttons"-midi-learn thing with the pk5 and the result was, that all what was coming out was on similar tone. i turned every knob and hit every single pedal on the pk5... the same tone over and over.
I really don't know what went wrong so if you PLEASE could help me. It would be so great.
Thanks a lot!!!
After Midi Learn only one similar output signal
-
- Posts: 2
- Joined: Tue Jul 05, 2016 3:07 pm
Re: After Midi Learn only one similar output signal
Which firmware did you install, and do you still have the firmware file that worked before?
-
- Posts: 2
- Joined: Tue Jul 05, 2016 3:07 pm
Re: After Midi Learn only one similar output signal
i applied the 2.0.0 and the one wich was applied before was the one it came with. now... next problem popped up this morning... my laptop doesn't recognize the unit anymore....
- paramnesia
- Posts: 126
- Joined: Tue Mar 03, 2015 11:35 am
- Location: Asheville, NC
- Contact:
Re: After Midi Learn only one similar output signal
which version of the USB Moog Midi driver are you using?
Sub37TE V1.2 / 4 X CP-251, 3 x MF-104M, MF-102, MF-107, MF-108M, 4 x Mother32, MP-201
My Eurorack https://www.modulargrid.net/e/racks/view/2268669
My Pedal Board https://www.modulargrid.net/p/racks/view/461843
My Eurorack https://www.modulargrid.net/e/racks/view/2268669
My Pedal Board https://www.modulargrid.net/p/racks/view/461843
Re: After Midi Learn only one similar output signal
is the sound a very low grumble? Do the note calibration routine. similar thing happened to me recently
Re: After Midi Learn only one similar output signal
I'm not sure what you're supposed to do with the calibration routine thing, but I used it recently.
I just let it go for a long time and then turned every knob. It seemed to be doing a lot of sweeps - filter and oscillator and whatnot.
No real directions I could find for it pertaining to how long it should take to complete.
I just let it go for a long time and then turned every knob. It seemed to be doing a lot of sweeps - filter and oscillator and whatnot.
No real directions I could find for it pertaining to how long it should take to complete.