Microbrute, Werkstatt & CV Newbie

Everything Werkstatt.
Post Reply
Lance
Posts: 3
Joined: Sun Jul 08, 2012 4:45 pm

Microbrute, Werkstatt & CV Newbie

Post by Lance » Tue Oct 27, 2015 7:02 pm

I'm trying to learn about using CV to control synths. I just installed my CV expander and was successfully able to control the Werkstatt with my QNexus keyboard. When I tried using my Microbrute as a sequencer, the pitch out seemed to work but not the gate. I can get a signal to the Werkstatt from the Microbrute but the keyboard on the Microbrute doesn't work unless I hold a key on the Werkstatt. Anyone used these two together and, if so, what am I doing wrong?

Struble
Posts: 36
Joined: Fri Dec 12, 2014 3:20 pm
Contact:

Re: Microbrute, Werkstatt & CV Newbie

Post by Struble » Sun Nov 08, 2015 7:41 pm

Lance, I've had the same problem. The work around I use is, instead of using the gate out on the Microbrute, I use the envelope out on the Microbrute into the VCA In on the Werkstatt. Hope that helps.
http://DepressedBoy.com

Equipment: Moog Werkstatt; Arturia Microbrute; Syntecno TeeBee; Elektron Sidstation; Korg Volca Keys, Electribe ER-1, Monotron; MidiNES; Teenage Engineering PO-12; Roland Boutique JP-08; BeatStep Pro; GameBoy

Lance
Posts: 3
Joined: Sun Jul 08, 2012 4:45 pm

Re: Microbrute, Werkstatt & CV Newbie

Post by Lance » Wed Nov 11, 2015 5:40 pm

Struble:
This works fantastically! Thanks so much for your help. I guess I now have to come up with my own explanation for why no one is going to see me for the next few days.

Struble
Posts: 36
Joined: Fri Dec 12, 2014 3:20 pm
Contact:

Re: Microbrute, Werkstatt & CV Newbie

Post by Struble » Wed Nov 11, 2015 8:03 pm

Yay. Glad I could help, Lance. The Werkstatt and the Microbrute make a mighty fine team.
http://DepressedBoy.com

Equipment: Moog Werkstatt; Arturia Microbrute; Syntecno TeeBee; Elektron Sidstation; Korg Volca Keys, Electribe ER-1, Monotron; MidiNES; Teenage Engineering PO-12; Roland Boutique JP-08; BeatStep Pro; GameBoy

Post Reply