Page 1 of 1
Moog slim stopped working ( all fixed now )
Posted: Tue Jul 21, 2015 3:20 pm
by mesa
My slim today when I plunged it a Cv/gate cables just died.
Screen has no text and is just white, the controls don't change when I turn them and none of the buttons work.
Holding the master button while turning on the unit dosn't load the debug so I can't load the firmware.
Is there any think I could do ?
Thanks
Re: Moog slim stopped working
Posted: Wed Jul 22, 2015 2:36 pm
by m10k
You'll probably have better luck directing your question to the Moog service department.
http://www.moogmusic.com/support/service
Re: Moog slim stopped working
Posted: Wed Jul 22, 2015 5:38 pm
by mesa
I have but no reply yer
Re: Moog slim stopped working
Posted: Wed Jul 22, 2015 6:33 pm
by m10k
Give it a couple of days and I'm sure they'll respond. Good luck and I hope you get it fixed ASAP!
Re: Moog slim stopped working
Posted: Wed Jul 22, 2015 6:40 pm
by mesa
I have opened it up, and have ordered a debugger, I just need to find out where I connect it to. I have seen it done to a little phatty but it's a lot different in side.
Re: Moog slim stopped working
Posted: Fri Jul 24, 2015 5:13 pm
by mesa
Used the debugger with some institutions from moog and it's all fixed now
Re: Moog slim stopped working ( all fixed now )
Posted: Fri Jul 24, 2015 5:54 pm
by stiiiiiiive
Cool!! Welcome back
Re: Moog slim stopped working ( all fixed now )
Posted: Sun Jul 26, 2015 6:09 am
by overthereinabox
What did you have to do to your SP to get it up and running again? Sounds like a major challenge that I do not want to have to go through, but it would be nice to know anway!