Page 1 of 1

LP CV out back into itself

Posted: Wed Jun 18, 2014 2:31 pm
by mrkennethdel
Is anybody else doing this? I find it to be very fun. The LP is my only piece of gear with CV.

Re: LP CV out back into itself

Posted: Wed Jun 18, 2014 4:41 pm
by stiiiiiiive
I NEVER DO THAT!!

Look why.

Re: LP CV out back into itself

Posted: Wed Jun 18, 2014 6:54 pm
by DonutDude
Good one stiiiiiiiive :)

Re: LP CV out back into itself

Posted: Wed Jun 18, 2014 11:43 pm
by David Smyth
mrkennethdel wrote:Is anybody else doing this? I find it to be very fun. The LP is my only piece of gear with CV.


Yes, it used to be my only piece of CV gear too. Being able to control volume with the (often MIDI-sync'd) built-in LFO is a bonus for things like tremolo sounds. My only wish is a "LFO DEST 1:OFF" setting to remove the internal modulation routing when patching back into itself, in a modular fashion. I asked Amos once and it's not possible, as the CV out signal IS taken directly from that internal routing.

I'd like to hear of any semi-modular patches using only a CV-Out-Modded Phatty, if anyone is willing to share!

Regards,
David
NZ

Re: LP CV out back into itself

Posted: Thu Jun 19, 2014 4:06 am
by stiiiiiiive
@DonutDude: ;)

More seriously, I tried a couple of times just to check it works I cannot remember what I patched though.

Re: LP CV out back into itself

Posted: Mon Jun 23, 2014 1:24 pm
by _DemonDan_
mrkennethdel wrote:Is anybody else doing this? The LP is my only piece of gear with CV.

Putting a CP-251 in between the LP CV Outs and the LP CV Ins gives you lots of new sound shaping power.

For those new to the Little Phatty, Control Voltage Outs are an optional mod (and well worth adding):

http://www.moogmusic.com/products/phatt ... dification

CV Outs were also available pre-installed on certain exclusive versions from several retailers.

Here's a video showing some of the things you can do with CV Outs:

https://www.youtube.com/watch?v=qkm-2OuIOhI

Re: LP CV out back into itself

Posted: Mon Jun 23, 2014 4:23 pm
by mrkennethdel
_DemonDan_ wrote:
mrkennethdel wrote:Is anybody else doing this? The LP is my only piece of gear with CV.

Putting a CP-251 in between the LP CV Outs and the LP CV Ins gives you lots of new sound shaping power.


I've contemplated one of these. The hesitation is because there's no way to sync to clock. I looked for an MP-201 for awhile but dang they're expensive.