3.1 Slim Phatty update gone awry...
Posted: Tue Feb 14, 2012 8:55 pm
I've been doing some searching on here and I have not seen anyone else with this problem...
I bought a Slim Phatty recently. Found out there was a firmware update, so I chose to install it. However, after following all instructions and going through the whole procedure, after the update, the functions of the buttons on my SP's panel are all mixed up (eg, pressing MASTER activates CURSOR, pressing OSC 2 FREQ activates OSC 1+2 SYNC).
Updated on Windows 7, 64-bit via USB
I've tried re-updating several times after restoring factory settings on the SP
I've tried running the phatty loader at the slowest speeds
I've led to the same result every time.
Help!
I bought a Slim Phatty recently. Found out there was a firmware update, so I chose to install it. However, after following all instructions and going through the whole procedure, after the update, the functions of the buttons on my SP's panel are all mixed up (eg, pressing MASTER activates CURSOR, pressing OSC 2 FREQ activates OSC 1+2 SYNC).
Updated on Windows 7, 64-bit via USB
I've tried re-updating several times after restoring factory settings on the SP
I've tried running the phatty loader at the slowest speeds
I've led to the same result every time.
Help!