Is there a way to remove the volume antenna and make the theremin output a constant high volume tone unaffected by proximity?
I use a pedal for volume, and the volume antenna is limiting my possibilities in regards of my setup.
I will gladly open it up and rewire it if thats what it takes. I would need some instructions in that case though..
Any options?
Remove the volume antenna?
- stiiiiiiive
- Posts: 2537
- Joined: Tue Aug 30, 2011 2:58 pm
- Contact:
Re: Remove the volume antenna?
Have you tried to set the volume calibration knob at an extreme value? So that the max volume is reached at few centimeters?
Toxic Overdrive | Minkovski | DNOT | Maetherial | Folie à 6
- Portamental
- Posts: 888
- Joined: Fri Jan 23, 2009 8:53 am
Re: Remove the volume antenna?
There's a document floating around (official from Moog) called modding and hotrodding your Etherwave. There's a mod included (page 9) on how to reverse the volume antenna. That should do it for you. A bit of basic electronics involved, but the procedure is clearly explained.
There's also a procedure (simpler) on how to control the Etherwave with an external pedal.
Here's the link : HotRodding the Etherwave
There's also a procedure (simpler) on how to control the Etherwave with an external pedal.
Here's the link : HotRodding the Etherwave
Last edited by Portamental on Sat Jan 28, 2012 9:25 am, edited 1 time in total.
- Portamental
- Posts: 888
- Joined: Fri Jan 23, 2009 8:53 am
Re: Remove the volume antenna?
See my edit of previous message for an even simpler way to use a pedal. No need to solder anything if you make the small jumper out of female RS232 pin connectors (or equivalent). Old wire wrap technique would also work.
Re: Remove the volume antenna?
Im seconds away from surgery here...
The instructions tell me to connect VCA OUT to +12V.
VCA OUT is already connected to something else..
Do I remove this connection? Or let it stay while adding the +12V to the party?
edit:
Remove old connection!
The instructions tell me to connect VCA OUT to +12V.
VCA OUT is already connected to something else..
Do I remove this connection? Or let it stay while adding the +12V to the party?
edit:
Remove old connection!