CP-251 bottom power supply?

Plug in here for info tips and strategies for your Moogerfooger Analog Effects. Connect more than one for plenty of fun!
Post Reply
leemccarthyn
Posts: 1
Joined: Fri Jan 18, 2019 1:14 pm

CP-251 bottom power supply?

Post by leemccarthyn » Fri Jan 18, 2019 1:28 pm

Hi

Have a couple of old CP-251 with the red jacks. They have power supply inputs on the topside and bottom. Just got one off e-bay which is the new model without the red rings. Does not have a power supply on the bottom, and has a plastic plug in the back panel where the supply jack should be. Was this changed with the newer models, or was this somehow modified by a previous owner? If it was changed, is there a way to get the part for the power supply to be in the back? Probably will rack this like the other units and I use the back supplies for them in the rack.

Thanks

electronicpoison
Posts: 67
Joined: Thu Feb 10, 2011 6:24 pm
Location: Hamburg

Re: CP-251 bottom power supply?

Post by electronicpoison » Sun Jan 20, 2019 11:03 pm

hello it is normal that you have two ways one for the rack and the other when you put the 251 on a table.

electronicpoison
Posts: 67
Joined: Thu Feb 10, 2011 6:24 pm
Location: Hamburg

Re: CP-251 bottom power supply?

Post by electronicpoison » Sun Jan 20, 2019 11:06 pm

sorry take the black plastic away and you got it ,i hope

elcubismo
Posts: 10
Joined: Tue Feb 12, 2019 1:26 am
Location: San Antonio, TX

Re: CP-251 bottom power supply?

Post by elcubismo » Fri Mar 01, 2019 5:04 pm

I had this same question, got mine on eBay as well and it had only the one power connection. Apparently it's just a matter of opening up the CP-251 and removing a screw that holds the power connector to the output port, then move it to the other port and put the screw back on. Haven't done it myself yet, but I'll get back to you soon if there are any gotchas!

Post Reply