Issue with mf-102 - please help!
Posted: Tue Oct 24, 2017 1:12 pm
Hello,
Here's the story: I plugged the ring mod into my mf-108's FB insert using a 1/8" Y cable with a 1/4" adapter (something like this http://www.proaudiostar.com/hosa-cmp-15 ... gJ4tvD_BwE) because I didnt have an insert cable. I wasn't sure which cable to put into the input/output of the mf-102 so I tried both configurations. Neither really worked, so I gave up.
But ever since then, my ring mod is acting funny. Mainly, the carrier oscillator now persists 1-2 seconds after the audio input decays (the level LED also persists 1-2 seconds after decay). It is dependent on where the mix knob is, but is not affected by the drive knob. It's relatively quiet, but still quite audible. Did I screw something up with my Y-cable nonsense, maybe short something?! What's going on? Please help!
Unfortunately I'm not the original owner, so I don't know if its still under warranty/if I can still send it in to moog.
Cheers,
Sam
Here's the story: I plugged the ring mod into my mf-108's FB insert using a 1/8" Y cable with a 1/4" adapter (something like this http://www.proaudiostar.com/hosa-cmp-15 ... gJ4tvD_BwE) because I didnt have an insert cable. I wasn't sure which cable to put into the input/output of the mf-102 so I tried both configurations. Neither really worked, so I gave up.
But ever since then, my ring mod is acting funny. Mainly, the carrier oscillator now persists 1-2 seconds after the audio input decays (the level LED also persists 1-2 seconds after decay). It is dependent on where the mix knob is, but is not affected by the drive knob. It's relatively quiet, but still quite audible. Did I screw something up with my Y-cable nonsense, maybe short something?! What's going on? Please help!
Unfortunately I'm not the original owner, so I don't know if its still under warranty/if I can still send it in to moog.
Cheers,
Sam