Drift with tap/step on 105M?
-
- Posts: 64
- Joined: Sun Sep 15, 2013 9:33 am
- Location: Norway
- Contact:
Drift with tap/step on 105M?
I have been sending a square wave into the tap/step input on the midimurf, and it seems to drift. Also, to get it to sync again it seems that I have to switch off the murf and reattach the wire. Anyone else experience this? Thanks
- latigid on
- Posts: 1579
- Joined: Mon Jan 30, 2006 3:47 pm
- Location: Auckland, New Zealand
Re: Drift with tap/step on 105M?
Can you explain (/audio/video) further? What's drifting? Relative to what? What's your clock source? Is it stable? Are you sending MIDI too?
I think the MuRFs might trigger on a falling edge, so if it seems out you could try inverting your squarewave before sending it to the tap/step input.
I think the MuRFs might trigger on a falling edge, so if it seems out you could try inverting your squarewave before sending it to the tap/step input.