Two questions about the Freqbox - OSC direct out

Rabalder · Post by **Rabalder** » Fri Jan 06, 2012 1:19 pm

- Is it safe to treat the OSC CV output as a normal audio signal, and send it to a normal input on a normal audio interface?
It doesnt burn up the input after a few weeks or something???

- Is the signal identical to the audio output pre-VCA..?

ColorForm2113 · Post by **ColorForm2113** » Sat Jan 07, 2012 12:13 pm

Its a pretty hot (loud) constant signal so you probably should put some sort of attenuator , or vca or volume pedal to prevent the freq from peaking and clipping your interface

Rabalder · Post by **Rabalder** » Mon Jan 09, 2012 5:11 am

ColorForm2113 wrote:prevent the freq from peaking and clipping your interface

So there is no real danger of damaging any gear?
Just a clipping-issue??

shortsleeves · Post by **shortsleeves** » Mon Jan 09, 2012 9:16 am

Rabalder wrote:
ColorForm2113 wrote:prevent the freq from peaking and clipping your interface
So there is no real danger of damaging any gear?
Just a clipping-issue??

I don't think you should damage anything with OSC Out – sometimes I put it straight back in to my Freqbox's Audio In, and all's well (so far at least

Cheers,
Lukasz

Rabalder · Post by **Rabalder** » Mon Jan 09, 2012 4:58 pm

Thanks..

Re-routed my whole setup today..

Freq volume output at 50%.
Interface input level in the yellow-zone..

No clipping.
Works perfect..
All good...

Moog Music Forum

Two questions about the Freqbox - OSC direct out

Two questions about the Freqbox - OSC direct out

Re: Two questions about the Freqbox - OSC direct out

Re: Two questions about the Freqbox - OSC direct out

Re: Two questions about the Freqbox - OSC direct out

Re: Two questions about the Freqbox - OSC direct out