Page 1 of 1
Moving the mf101's cutoff frequency?
Posted: Tue Jul 19, 2011 1:54 am
by nrvana8775
I was wanting to shift the cutoff frequency using various waveshapes. It doesn't really seem to work as I expected. For instance, keeping the cutoff at 250, I'll hear the lfo, but it will be at 250 hz. I would like to shift the frequency from the 250hz to 1khz (just an example) range using a square wave. I figured that I could do this with my mp201 or lightfoot labs goatkeeper, but it isn't really working.
Any suggestions?
Re: Moving the mf101's cutoff frequency?
Posted: Tue Jul 19, 2011 2:10 am
by noSpoonMusic
Have you tried adjusting the LFO amount?
Re: Moving the mf101's cutoff frequency?
Posted: Tue Jul 19, 2011 10:34 am
by nrvana8775
noSpoonMusic wrote:Have you tried adjusting the LFO amount?
The lfo amount is at full (4,000 something) on the mp-201. I don't think the goatkeeper will really work as a source, but the problem is that the mp-201 lacks many of the waveforms.
Re: Moving the mf101's cutoff frequency?
Posted: Wed Jul 20, 2011 4:11 am
by Pantherairsoft
Something isn't set up right then… I use my MP-201 for just this thing…
Using a TS jack-jack?
Unipolar or Bipolar?
What are the knobs on the fooger' set to? (take a pic for us?)
What settings are you currently set to on the MP-201?
Shep