Page 1 of 1

ARP & hold

Posted: Fri Nov 22, 2019 3:02 am
by afewster
I'm having issues with the arpeggiator and hold. v1.1 firmware.
Steps to reproduce;

Validate hold only:
init patch, press hold, play three notes, one after the other - a simple triad chord is created.

Validate Arpeggiator:
Disable hold - activate arpeggiator - play and hold one note after another (C,F,G) - all three notes are arpeggiated.

Both together (issue)
Press hold, play and hold one note after another (C,F,G) - only C is arpeggiated.

Is this expected behavior?

Re: ARP & hold

Posted: Fri Nov 22, 2019 3:47 pm
by noisebit
Hi,

I validate hold only:

I press init, hold, play three notes C F G one after the other:
I hear C F and G - only as a single note.

I disable hold and activate the arp:
I play the 3 notes and hold them: I hear all 3 notes with arp.

I press hold and activate the arp:
When I play and hold one note after another (C,F,G) all notes are arpeggiated.

This is the expected behavior for me.

I can't reproduce your issue with firmware 1.1.0

Best regards.

Re: ARP & hold

Posted: Sat Nov 23, 2019 1:30 am
by afewster
Rookie error! Disconnected Ableton from the Moog One, and all is well again..

Re: ARP & hold

Posted: Mon Nov 30, 2020 4:08 pm
by TheDigitalMan
Hi, I've been wondering about this behaviour too. I"m unsure why the hold is only holding / sounding 1 key with the arp?